Here list of some most common faults of the magnetic flowmeter and the troubleshooting. 1. No display No power Apply correct power Fuse blown Replace a fuse with the same parameter The contrast of LCD is too low Increase the contrast 2. Empty Pipe alarm Fluid is not full filled the pipe Increase the flow […]
Magnetic flow meter troubleshooting Read More »
The target flowmeter first appeared in the 1960s and was originally mainly used to solve the flow measurement problem of high viscosity and low Reynolds number fluids. The typical application has gases and liquid field. Gases: coal gas, air, compressed air, hydrogen, natural gas, oxygen, nitrogen, liquefied petroleum gas, hydrogen peroxide, flue gas, methane, butane,
Target flow meter application Read More »
Earthing rings are normally used or suppress electrical interference at the location of installation for magnetic flow meters. Hence, they are offered in pairs and the installation happens upstream or downstream of the flow meter. The good thing about grounding rings is that their design is meant for installation between the series of magnetic flow
Magnetic flow meter earthing ring Read More »
Electromagnetic flow Meter Accuracy Electromagnetic flow Meter accuracy is how close the measurement is to the true value. That means how close the output of the meter is to its calibration curve. Zero Instrument calibration was performed on every meter, within ±0.5% of reading accuracy at the calibrated (typical) flow velocity and within ±1-2% of
Electromagnetic flow meter accuracy Read More »
1. See if the power is working When the radar level of the liquid level to a certain value after the change is very slow, should check the power supply, whether the normal power, whether the normal output after power. When there is no change in the liquid level, it is necessary to check whether
Causes of inaccurate display value of radar liquid level meter Read More »
It is known from fluid mechanics that when liquid flows in a pipe, the velocity of each point on the Cross section of the pipe is not equal, but the velocity distribution can become axisymmetric after a certain distance of straight pipe, no matter Laminar or turbulent flow The velocity is maximum at the center
Influence of velocity distribution of electromagnetic flow meter Read More »
ABSTRACT: In the aspect of failure rate, the vortex flow meter designed and produced by us has a low rate from the user’s feedback, and the failure is usually solved after we have re-installed it In fact, the first thing to check is when there is a failure is whether the installation is strictly in
Trouble shooting and treatment of Vortex flow meter Read More »
We got regular requirements from our Athens Greece customer. Medium: DN80 – sludge, DN 150 – raw water Electromagnetic flowmeters Diameter DN80 and DN150 Power Supply 24 VDC It should be sent by Airplane cause of an urgent application. Now the flow meters have been finished production and will be seen The flow meters supplied
Zero Instrument Electromagnetic flowmeters apply to the raw water in Greece Read More »
