admin_zero

Where:5xDN and 250 are the straight tube section in the front and rear of the flowmeter,100 is the pre-left position for installation of the magnetic filter.       Notices on installation instrument Before installation of the instrument, the process lines should be blown off to prevent ferromagnetic substances from staying in pipes from adhering […]

Mass flow meter dimension, flow range, pressure, Zero stability, and Velocity Parameter.  

The principle of density measurement by mass flowmeter. Can mass flow meters measure density? The answer is yes. The principle is explained below: One end of the flow tube is fixed, while the other end is free. This structure can be regarded as a weight/spring system composed of a weight suspended on a spring. Once

24VDC±10% Power consumption: 7W (basic power supply) 220VAC Power consumption: 10W (additional power supply) The power supply of the essential safety explosion-proof transmitter (secondary meter) is AC 220V/50Hz. Power consumes less than 15W. The power supply of the composite explosion-proof transmitter (secondary meter) is DC 24V. Power consumes less than 15W. Power wires in the

Meter K-Factor is defined as the number of pulses per unit mass or volume at a particular flow rate. Every meter in each turbine contains a K-Factor or a ratio of the pulses per unit of flow. Coriolis flowmeters do not have a fixed K-factor (number of pulses output per unit of flow). The number

Advantages of Coriolis Mass Flowmeters True mass flow measurement. Multi-parameter measurement, while measuring the mass flow, the volume flow, additional temperature, and density can be obtained at the same time. Very high accuracy for mass flow measurements. Highly accurate density measurement. Unaffected by pressure, temperature, and viscosity. Easy to install, clean, and maintain, no inlet

The mass flow meter can be used in the following fields to meet the requirements of ingredients, mixing processes, and commercial measurement. Chemical: containing a chemical reaction system. Petroleum: moisture content analysis. Lipids: including vegetable oils, animal fats, and other oils. Liquid Flow Sensors That Provide Accurate Flow Rate Measurement. Pharmaceutical. Painting. Precision Measurement &

Coriolis mass flow meters are of high measurement accuracy. A liquid mass flow accuracy of 0.1% is common and 0.05% is also available. Gas mass flow accuracy to 0.25% is available, although 0.35-0.5% is a more common selection.

Target flowmeters measure flow by measuring the amount of force exerted by the flowing fluid on a target suspended in the flow stream. The force exerted on the target by the flow is proportional to the pressure drop across the target. When flow medium flows through measure tube, the pressure will force on the target

Trouble Shooting The flow meter displays non-zero, while the flow velocity is zero. The following reasons and solution methods may be included Flowmeter was not installed in a strictly horizontal position. Solution: zero set operation. Flowmeter has run for a long time and error occurs. Solution: zero set operation. Overloading brings zero offsets. Solution: zero