admin_zero

The following table includes the line size, flow range, max tube pressure, zero stability, and velocity parameter. Specs Line Sizes (mm) Flow Range (t/h) Calibration Range (t/h) Max. Tube Pressure (MPa)  Zero Stability (t/hr) Velocity Parameter (h m/t s) DN1 1 0～0.04 0.004～0.04 30 0.000008 353.7 DN3 3 0～0.35 0.035～0.35 30 0.000067 39.3 DN6 6 […]

Z100M series mass flow meter sensor consists of a measurement tube, driving device, a position detector, support structure, the temperature sensor, housing, etc. ①Supporting structure: the measuring tube fixed on the supporting structure as the vibrating axis. ②The measuring tube (Vibrating tube): consist of two parallel tubes. ③Position detector: used for the measurement of measuring

Foreword The measurement principle of the target flowmeter is: a target plate is set in the center of the circular measuring tube and the direction perpendicular to the flow beam, and the fluid flows along the annular gap around the target plate. Due to the flow of the fluid, the force is generated on the

Coriolis mass flow meter is a new type of flow meter which is designed according to Micro Motion and Coriolis principle. This kind of new flow meter can measure the fluid directly in a sealed pipeline. It consists of two sections: Sensor and Signal Transmitter。 For more details, welcome to check the following catalog.  

Target flow meter standard water flow rate table Diameter (mm) Flow rate (m3/h) Range ratio of target to diameter Pressure drop (kPa) 15 0.1-3 0.8-0.5 75.53 20 0.17-5 0.8-0.5 55.12 25 0.3-9 0.8-0.4 34.45 32 0.5-14 0.8-0.3 24.12 40 1.0-24 0.8-0.3 17.23 50 1.5-40 0.8-0.3 6.89 65 2.5-60 0.7-0.35 5.51 80 3.5-90 0.7-0.35 4.31 100

When the target flowmeter was selected, first measure the medium flow range and caliber. If measuring general media, the full-scale flow rate of the target flowmeter can be selected within the range of 0.5-12m/s of the measured medium flow rate. The instrument diameter is not necessarily the same as the processing pipeline. It should be

When the target type flowmeter is measuring, the actual fluid will generate viscous friction when passing through the target, and a vortex will be generated behind the target, which will consume a part of the fluid and energy and cause pressure loss. The pressure loss is related to the caliber of the flowmeter, target diameter

The plug-in target flow meter is a new type of capacitive force induction flow plug-in target flowmeter developed on the basis of the traditional target flow meter and with the development of new sensors and microelectronics technology. It has an orifice plate Flowmeters such as vortex and vortex flowmeters have no moving parts, and at

The remote transmission type vortex flowmeter separates the sensor part from the display part. The remote compensation type vortex flowmeter is mainly composed of a vortex flow sensor, an intelligent flow totalizer, (platinum thermal resistance or pressure transmitter), a wall-mounted instrument box, etc. The display part can be placed at any position within a certain

Minimum flow problem The amplitude of the vortex signal is proportional to the square of the velocity of the measured medium and the density. In other words, when the detection sensitivity of the vortex flowmeter is constant, the working pressure of the fluid increases and the density increases, and the measured flow rate can be