admin_zero

When transporting and hoisting the sensor, the sling should be put on the neck position or the hoisting ring at both ends of the sensor. Do not put a pipe rod in the measuring tube for hoisting, so as not to damage the lining (see Figure 6-27). During hoisting and transportation, the sensor lining and […]

The electromagnetic flow sensor lining made of polytetrafluoroethylene (PTFE) pipe is generally not glued to the wall of the sensor measuring tube, so it is sensitive to vacuum negative pressure. The vacuum in the pipeline will deflate the PTFE lining, making the lining arched in a wave-like shape—a typical negative pressure damage pattern. This destroys

Because large-diameter pipelines are buried in the ground on most occasions, a cement pit should be made before the installation of large-diameter sensors. Figure 6-19 shows a common installation form in the water supply and drainage system. The concrete pit should have enough space for movement. The side walls are buried with steel pipes for

The integrated electromagnetic flowmeter does not need to install a converter separately. The split-type converter is installed near the sensor or in the instrument room, where there is more room for choice, and the environmental conditions are better than the sensor. Its protection level is IP65 or IP64 (dust-proof and splash-proof). The requirements of the

The inlet of the piping system of the process industry is often connected to a container or a high-level tank, and the inlet of a public utility piping system is often connected to a pool or a river channel. The inlet must have a distance of 2-5 times the diameter of the inlet pipe below

The liquid flowing in the pipe may be mixed with air bubbles due to various reasons. For example, if the flow sensor is installed horizontally at the high or second high point of the piping system, it is easy to accumulate on the upper part of the horizontal pipeline and the flow sensor measuring tube,

The degree of influence of the magnetic field on the electromagnetic flow sensor varies greatly depending on the structural material and design of the sensor protective housing. For example, some shells are made of ferromagnetic materials such as steel plates, which have a better magnetic shielding effect and have less impact; others are made of

Material Performance characteristics Applicable fluid Precautions Overall 1. The inner surface is smooth, and it is not easy to adhere to the deposited layer 2. Superior corrosion resistance 3. Wide fluid temperature range 1. High permeability liquids such as hydrofluoric acid, hydrochloric acid, and acetic acid 2. Sulfuric acid, caustic soda, electrolyte, and other strong

The liquid flow rate of the electromagnetic flowmeter at full-scale flow can be selected within 0.5-10m/s, and the range is relatively wide. The upper limit flow rate is not limited in principle due to the small resistance loss of the instrument. However, it is generally recommended not to exceed 5m/s, unless the material in the

The performance of general-purpose electromagnetic flowmeters on the market is quite different. Some have high accuracy and many functions; some have low accuracy and simple functions. The accuracy grades of high-precision instruments are 0.5 and 1, the basic error is usually ±(0.5-1)%R, and the low-precision instruments are ±(1.5-2.5)%FS. Some models of instruments claim that the