Level meter

The development of science and technology has led to higher protection levels, wider applications, and easier installation of radar water level meters. However, the installation is easy, but the radar water level meter installation considerations, we still need to understand to ensure the accuracy of the measurement. 1. Installation location considerations Firstly, most radar level […]

Firstly, when measuring solid materials, the non-contact radar level meter (radar level meter) must be far away from the inlet. In general, the installation port should be chosen at a distance of more than two meters from the inlet, which is the best position. If conditions do not allow, the nearest installation port should also

Water, the medium, has the great characteristic of being colorless and odorless. Therefore, it is not corrosive and even less viscous. Therefore, these medium working conditions are relatively simple. Nevertheless, when installing the radar water level meter, we still have to pay attention to the following aspects. First, when installing, pay attention to the horizontal

The guided wave radar level meter is a type of radar level meter, which belongs to the contact radar level meter. The biggest difference between this level meter and a non-contact radar level meter lies in the antenna part. The antenna (detection component) used in a guided wave radar level meter is usually a steel

The microwave pulses emitted by the radar level meter are electromagnetic waves. If there is an electromagnetic field around, the radar level meter will definitely be affected and the measurement will definitely be inaccurate. What can be done about this situation? Engineers recommend the addition of a signal filter, which allows the radar receiver to

Computer software equipment is mainly used for office or living needs, while the hardware is the most basic condition factor to support the operation of the software. Radar level meter software is mainly used for equipment debugging, hardware is the normal operation of the level meter necessary components, such as antennas, flanges, shells, and so

Although not as widely used as non-contact radar level meters, guided wave radar level meters can occasionally be seen in all walks of life. Therefore, it is very necessary and crucial to understand the common faults of guided wave radar level meters as well as clear inspection ideas. Radar level meter faults can basically be

As the level of automation continues to improve, radar level meters are used in an increasingly wide range of applications. In the use of the process, radar level meters will also appear in a large or small problem. The usual solution to these problems is to identify the cause of the fault and solve the

Guided wave radar level meter selection, need to consider many factors, such as working conditions, media characteristics, etc. In fact, the guided wave radar level meter installation, also need to consider a lot, especially a few considerations are necessary to know. Do not install the steel cable too loosely when installing the guided wave radar

How to install a radar level meter in a storage tank with a heating coil. Next, we start with a case study to understand the influence of the heating coil on the radar level meter measurement. Case. Client name: A chemical plant Service location: Ningxia Detailed site conditions (temperature, pressure, medium): liquid alkali, hydrochloric acid,