Flow meter

24VDC±10% Power consumption: 7W (basic power supply) 220VAC Power consumption: 10W (additional power supply) The power supply of the essential safety explosion-proof transmitter (secondary meter) is AC 220V/50Hz. Power consumes less than 15W. The power supply of the composite explosion-proof transmitter (secondary meter) is DC 24V. Power consumes less than 15W. Power wires in the […]

Meter K-Factor is defined as the number of pulses per unit mass or volume at a particular flow rate. Every meter in each turbine contains a K-Factor or a ratio of the pulses per unit of flow. Coriolis flowmeters do not have a fixed K-factor (number of pulses output per unit of flow). The number

Advantages of Coriolis Mass Flowmeters True mass flow measurement. Multi-parameter measurement, while measuring the mass flow, the volume flow, additional temperature, and density can be obtained at the same time. Very high accuracy for mass flow measurements. Highly accurate density measurement. Unaffected by pressure, temperature, and viscosity. Easy to install, clean, and maintain, no inlet

The mass flow meter can be used in the following fields to meet the requirements of ingredients, mixing processes, and commercial measurement. Chemical: containing a chemical reaction system. Petroleum: moisture content analysis. Lipids: including vegetable oils, animal fats, and other oils. Liquid Flow Sensors That Provide Accurate Flow Rate Measurement. Pharmaceutical. Painting. Precision Measurement &

Coriolis mass flow meters are of high measurement accuracy. A liquid mass flow accuracy of 0.1% is common and 0.05% is also available. Gas mass flow accuracy to 0.25% is available, although 0.35-0.5% is a more common selection.

Target flowmeters measure flow by measuring the amount of force exerted by the flowing fluid on a target suspended in the flow stream. The force exerted on the target by the flow is proportional to the pressure drop across the target. When flow medium flows through measure tube, the pressure will force on the target

Trouble Shooting The flow meter displays non-zero, while the flow velocity is zero. The following reasons and solution methods may be included Flowmeter was not installed in a strictly horizontal position. Solution: zero set operation. Flowmeter has run for a long time and error occurs. Solution: zero set operation. Overloading brings zero offsets. Solution: zero

The target flow meter output signal has 4-20mA, 0-10V, impulse, and RS485 outputs for options.

Turndown ratio is often referred to as the rangeability of an instrument. It is defined as the ratio of the maximum capacity of measurement to the minimum requirement for measurement. It is expressed as a multiplication factor from the lowest range to the highest range. Ultrasonic flow meter usually has a turndown ratio of  250:1.

The correct selection of the target flowmeter can ensure the better use of the target flowmeter. What kind of target flowmeter should be selected according to the physical and chemical properties of the fluid medium to be measured? The diameter, flow range, and output mode of the target flowmeter can be adapted to the nature