admin_zero

If the primary selection has been determined to adopt the electromagnetic flowmeter measurement method, the instrument selection becomes the specific electromagnetic flowmeter selection, and several factors in the five aspects of the appeal must be reconsidered. However, the focus of consideration has shifted from the selection of instrument varieties to the comparison and selection of […]

Because of its simple structure, reliable performance, intuitive reading, small and constant pressure loss, approximate linear scale, wide measurement range, convenient maintenance, and low price, the float flowmeter is widely used in flow measurement and control occasions such as liquids and gases. In the application of various types of flow meters in China, it has

Turbine flowmeters are widely used. They can be used in measuring instruments for trade settlement of crude oil, natural gas, and valuable fluids, and can also be used in product production process control, as the feedback signal provider and controller of the control system. Turbine flowmeter has high accuracy, especially good repeatability, so it has

Coriolis Mass flow meter, also known as Coriolis mass flow meter, is a flow measuring instrument that adopts a new measurement principle. It has developed rapidly since it entered commercialization in the early 1980s. Coriolis mass flowmeters can be used in petrochemical, chemical, pharmaceutical, paper, food, and energy industries. They have been widely used in

Dimethyl terephthalate (DMT) is a medium with complicated process operations and physical properties. Its particularity is shown in: (1) The process is intermittent feeding; (2) The operating temperature is around 165℃ all year round, and the highest is 195℃; (3) When the temperature is higher than 145℃, the density is about 1.065g/cm3, When the temperature

Most of the liquefied gas is stored in spherical tanks. The conventional measurement method uses a glass plate level gauge installed on the spherical tank or a manual gauge to measure the volume, and then calculate the mass based on the density value measured by offline sampling. Regardless of whether you use a glass plate

Customer request: Zero Instrument supply for our customers: Liquid turbine flowmeter, 304 stainless steel body, 2Cr13 impeller, On-site display, 24V power supply, 4-20mA output + RS485 communication, National standard flange connection (without matching flanges, bolts, and nuts), Pressure resistance 4.0MPa, Temperature resistance  -20~80℃, Protection grade IP65. The turbine meter measurement range is as follows: DN15

Since the flow rate range of liquid and gas is very different, the frequency range is also different. In the amplifier circuit that processes the vortex signal, the circuit parameters of the filter are different. Therefore, the same circuit parameter cannot be used for different measurement mediums. When the medium changes, the circuit parameters should

High-viscosity liquid medium refers to liquids with high viscosity such as crude oil, heavy oil, and residual oil. In the past, volumetric flowmeters were mostly used to measure this type of liquid, and some other flowmeters such as target flowmeters were also used, but these flowmeters directly measured the volume of the liquid, not the

Structurally, the sensor and converter form a whole, which is called an integrated electromagnetic flowmeter. The integrated electromagnetic flowmeter can reduce excitation and signal transmission cables during installation and use, save installation costs, and bring convenience to on-site operation and on-site instructions, and its instrument manufacturing cost is relatively low. Therefore, integrated electromagnetic flowmeters are