Product Overview
◆ No thermal drift, negligible temperature shift, and time drift, long-term stability 0.1% F.S/year
◆ Accuracy 1.0%, range can be set in 100:1 range by key, no need to calibrate.
◆ Instantaneous and cumulative flow, pressure, and temperature can be displayed at the same time.
◆ No need to warm up, no response lag during measurement.
◆ Built-in 30 kinds of gas conversion coefficients, no specific heat capacity additional error, does not affect the accuracy.
Product Applications
ACU10FC adopts the principle of differential pressure mass measurement without thermal drift and response lag, and can simultaneously display and output: instantaneous flow rate, cumulative flow rate, pressure, temperature and so on, cumulative flow, pressure, temperature, etc.
When control functions are required, electromagnetic proportional control valves and built-in PID regulation can also be added.
Unlike thermal flow meters, the ACU10FC has no additional “specific heat capacity” error when using gas conversion factors. Therefore, even if
Therefore, even if the measurement gas is different from the factory calibration gas, the measurement accuracy will not be affected.
ACU10FC series mass flow meters/controllers are widely used in various industrial fields, such as process manufacturing, food analysis, analytical testing metrology, etc. Multi-variable measurement and 50:1 range adjustable ratio, so that only one ACU10FC gas flow meter & controller can replace the effectiveness of multiple devices. Accuracy of 1%, repeatability of 1%, and a control response time of less than 200 milliseconds ensure that process gases work properly.
Technical Parameters
Accuracy | ± 1% F.S | |
Repeatability | ± 1% F.S | |
Zero-point drift and full-scale drift | 0.02% F.S/ ºC/Atm | |
Operating range/range adjustable ratio | 2% ~ 100% F.S / 50:1 | |
Maximum Measurable Flow Rate | 100% F.S | |
Response time | 200 ms (Adjustable) | |
Start-up warm-up time | less 5 seconds | |
LCD Display | Simultaneous display of flow rate, settings | |
Digital output signal | RS-485 / PROFIBUS | |
Analog input/output signals | 0-5 Vdc / 4-20 mA | |
Power supply | 24-30 Vdc | |
Supply current | 0.250 Amp | 0.750 Amp |
Maximum working pressure | 3 MPa / 10MPa | |
Protection level | IP40 | |
Material | Stainless steel |
Product Size